RepRapPro 3D-Skrivare

Duex 2 - 2 port expansion board

Duex 2 - 2 port expansion board
819 SEK
Duex 2 - 2 port expansion board 

The Duex2 has the following features:

  • 2 additional TMC2660 stepper motor drivers with stall notification.
  • 2 additional extruder heater outputs.
  • 2 servo outputs with 5V power and 5V signal levels, sharing control channels with the heaters, so you can use unused heater channels to drive servos.
  • 2 additional endstop inputs with indicator LEDs and 3.3V/5V voltage selection. These are also usable as outputs.
  • 2 additional controlled fan outputs, also usable for driving LEDs etc. The output voltage may be switched between 5V, 12V and VIN.
  • 4 uncommitted general purpose I/O pins.
  • 12V switching regulator, for generating a 12V supply for fans, LEDs etc. when the VIN power is higher than 12V.
  • 2 additional thermistor inputs.
  • Support for 2 more thermocouple or PT100 daughter boards, supporting up to 4 more sensors.
  • Optional 5V external power input for powering servos, fans etc.

The Duex2 has the same feature list, just with 2 channels of everything, rather than 5. Both are supplied with the 50 way connector cable between the DuetWifi and the Duex.

For more information see the Wiki.

Tags: 3dskrivare, reprap 3dprinter, Wanhao, Prusa i3, Duplicator, Duet, Wifi, Reservdelar, Anet, A8, CR10, CR10S, Creality, Sverige, Styrkort, Controller board