PrintaFix Basic 500ml
PrintaFix Basic
PrintaFix - the best solution for adhesion problems in 3D printing, no warping anymore.
easy to use –simple as Shake | Spray | Print!
cost-effective
for non-heated and heated printbeds
removable with warm water
environmentally friendly
PrintaFix Basic is developed particularly for FDM/FFF 3D printing and is characterized by its ease of
use, the low price per print and excellent adhesion on non-heated and heated printbeds.
With PrintaFix you solve problems with the adhesion far better and more convenient that with other products.
Instruction:
shake -spray - print
Take the printbed out of your 3D printer, shake PrintaFix well, apply overlapping circles on the printbed and start the print as usal.
Warping and first layer problems is a thing of the past.
Clean up is done in seconds. Just use warm water or an alcoholic window cleaner (must contain ethanol).
More information:
Recommended settings:
PLA: printing temperature 200-215°C
ABS: printing temperature 235-250°C
Printbed temperature 80-100°C with 5mm brim when using ABS
You will get a smooth and nice finish on the bottom.
Multiple prints on one PrintaFix coating are possible (Adhesion drops about 20% per print depending on the size of the previous model.)
For extreme high adhesion:
Spray PrintaFix as usual in overlapping circles on the printbed. Wait until it is dried. Thenspray again a fine nebula with a few pumps from a distance of 30 cm on the printbed.
Tags: 3D skrivare, prinafix, Reprap, Köpa, Sverige, 500ml, Wanhao, i3, Anet, A8, CR10s, CR10, Creality, Reservdel, Reservdelar