RepRapPro 3D-Skrivare

UNO R3 board MEGA328P

UNO R3 board MEGA328P
169 SEK
UNO är en microcontroller board baserad på ATmega328P.

Den har 14 digital input/output pins (6 av dom kan användas som PWM outputs), 6 analog inputs, en 16 MHz quartz crystal, en USB kontakt, Strömkontakt, en ICSP header och en reset knapp.

It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started.. You can tinker with your UNO without worrying too much about doing something wrong, worst case scenario you can replace the chip for a few dollars and start over again.

MicrocontrollerATmega328P
Operating Voltage5V
Input Voltage (recommended)7-12V
Input Voltage (limit)6-20V
Digital I/O Pins14 (of which 6 provide PWM output)
PWM Digital I/O Pins6
Analog Input Pins6
DC Current per I/O Pin20 mA
DC Current for 3.3V Pin50 mA
Flash Memory32 KB (ATmega328P)
of which 0.5 KB used by bootloader
SRAM2 KB (ATmega328P)
EEPROM1 KB (ATmega328P)
Clock Speed16 MHz
Length68.6 mm
Width53.4 mm
Weight25 g

Tags: 3dskrivare, reprap 3dprinter, Wanhao, Prusa i3, Duplicator, Arduino, ATmega, UNO, R3