RepRapPro 3D-Skrivare

Volcano - Eruption Pack - 1.75mm

Volcano - Eruption Pack - 1.75mm
519 SEK

Volcano - Eruption Pack - 1.75mm

From mid-June 2016 E3D Hotends will transition to using a standard cartridge-type format for temperature sensors. This means a new heater-block and thermistor cartridge will be supplied with the E3D-v6 as standard. For a full explanation read the sensor documentation page.

Volcano - Print Faster, Stronger, Bigger.

Everything you need to start exploring large format 3D-Printing! The Eruption Pack is an add on for your E3D HotEnd to boost the speed of printing with vastly increased melt rates and epic layer adhesion. Another fun addition to the E3D ecosystem, and fully compatible with all E3D HotEnds except Cyclops.

The Eruption Pack gives you an easy way to upgrade your HotEnd with a full suite of nozzles. This kit contains all the parts you need to upgrade your HotEnd to Volcano, including electronics and fixings. The Eruption Pack adds the full range of nozzle sizes to your Volcano:

  • 0.60mm
  • 0.80mm
  • 1.00mm
  • 1.20mm

A fully featured and great value way to get going with Volcano.


Volcano is E3D's answer to slow printing. If you want large parts, in less than half the time, with dramatically increased strength then Volcano is what you need.

Volcano enables you to print at high layer heights, through large nozzles, and extrude much more plastic per second. This results in dramatically reduced print times.

Tags: 3dskrivare, E3D, Volcano, Munstycke, Uppgradering