Gen V1.2 Styrkort för 3D skrivare
Arduino MEGA compatible
Atmega2560 and FT232 processors are compatible with all RAMPS class firmware
Easy DISPLAY + SD-CARD connector
RepRapDiscount SmartController compatible pin header on board
Easy connect MKS TFT on AUX-1
All extra pins broken out the same as ramps1.4(AUX-1,AUX-2,AUX-3,Servos1) 3x temperature ADC connectors for thermistors up to 5 motor driver with easy micro stepping setup (micro switches) 4x PWM capable power mosfet outputs with voltage selector for MainPower.(Bed,Extruder0,Extruder1, Fans) 4 layers PCB, optimize heat dissipation. 3*5V output, 3*12V output interface. 6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax Recoverable fuse for short-circuit protection.
